CO is an acronym for which of the following? A.) Central Office B.) Capita

CO is an acronym for which of the following?

A.) Central Office

B.) Capital Office

C.) Central Operator

D.) Company Office

Question Posted / guest

1 Answers
4184 Views
I also Faced
E-Mail Answers

CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Cent..

Answer / guest

Answer: A

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More CCNA Interview Questions

HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS PREFERED OVER ANY NETWORK PROTOCOL?

1 Answers Bank Of India, TCS,

Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-

1 Answers

Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack

2 Answers

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers Karrox,

What is a Window in networking terms?

0 Answers

What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers

What is raid in ccna?

0 Answers

Explain what is the size of hello packets in eigrep protocol?

0 Answers

What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase

2 Answers

The "ipx delay number" command will allow an administrator to change the default settings. What are the default settings? A. For LAN interfaces, one tick; for WAN interfaces, six ticks B. For LAN interfaces, six ticks; for WAN interfaces, one tick C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks D. For LAN interfaces, five ticks; for WAN interfaces, zero Ticks

1 Answers

Explain usage of ICMP in IP routing

3 Answers

The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers

For more CCNA Interview Questions Click Here