Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network
2 5590Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
2 5127What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable
1 3919WAN stands for which of the following? A.) Wide Arena Network B.) World Area Network C.) Wide Area News D.) Wide Area Network
1 2814Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP
1 3062Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells
3 5444Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
2 5006Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP
1 3080What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS
1 3556The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters
1 3330What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector
3 4645Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation
2 7814
Which command we give for see routing table?
Mention the conversion steps of data encapsulation?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What does vlan provide?
Tell me which protocol works only on cisco routers?
Explain the terms unicast, multicast, broadcast.
What are the different types of VPN?
What is the size of hello packets in eigrep protocol?
Can you explain PPP link process step by step?
What are the three sources of signal degradation on a data link?
What is the difference between unicast, multicast, broadcast, and anycast?
Explain the difference between collision domain and broadcast domain.
What are the different types of cables that are used in routing?
What is BootP?
What is the virtual path?