What is the purpose of Split Horizon?
A.) It prevents the regular update messages from reinstating
a route that
has gone down
B.) Information received on an interface cannot be sent back
out the same
interface
C.) Informs all neighbor routers that two routes exist
D.) Tells the router the destination is unreachable
What is the correct command line syntax for configuring a port on a 7000 or 7500 series Cisco router with a VIP card? A.) port B.) port adapter/port C.) You can't put a VIP card in a 7000 or 7500 router. D.) slot/port-adapter/port E.) slot/port F.) slot
which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?
What is the diiffernce between windows xp & windows 2000?
6 Answers TCS, Trimax, Trymax, VigaTech,
Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts
How we can find ASBR Router, we have no authentication to enter router?
Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector
Which of the following is an invalid host address using a netmask of 255.255.255.192? A.) 10.1.1.1 B.) 10.1.1.66 C.) 10.1.1.130 D.) 10.1.1.127
What is the multicast routing?
Value in which type of access list?
The Internet Protocol (IP) occurs at what layer of the seven layer model? A.) Physical B.) Presentation C.) Network D.) Datalink E.) Session F.) Transport
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'