How many LMI types are available on Cisco routers? A.) Four B.) Two C.)

How many LMI types are available on Cisco routers?

A.) Four

B.) Two

C.) Five

D.) Three

Question Posted / guest

3 Answers
6521 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three..

Answer / guest

Answer: D

Is This Answer Correct ?

4 Yes

0 No

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three..

Answer / yogesh bhardwaj

three

Is This Answer Correct ?

2 Yes

0 No

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three..

Answer / vivek

d.)
Cisco supports three different Local Management Interface
(LMI) types for Frame Relay

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More CCNA Interview Questions

How many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers

What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category

3 Answers

what is the difference between 1 router and switch 2 router and hub 3 hub and switch 4 bridge and switch

1 Answers Hathway,

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

3 Answers

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers

which device/card is used at the end of computer/device to connect multiple or different wire of mesh topology to a single computer/device?

1 Answers Adepto, British College, Wipro,

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers

What is the bit length and expression form of a MAC address? A. 24 bits expressed as a decimal number B. 24 bits expressed as a hexadecimal number C. 36 bits expressed as a binary number D. 48 bits expressed as a decimal number E. 48 bits expressed as a hexadecimal number

2 Answers

What is the difference between switch and hub?

0 Answers

How is rip different from igrp?

0 Answers

The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers

What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

2 Answers

For more CCNA Interview Questions Click Here