Why Authentication Header (AH) is not compatible with the network that using NAT?????? Jitu, looking for u specially...!!!! U knw why i m looking for u..!!!

Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

A banana plantation is located next to a desert. The plantation owner has 3000 bananas that he wants to transport to the market by camel, across a 1000 kilometre stretch of desert. The owner has only one camel, which carries a maximum of 1000 bananas at any moment in time, and eats one banana every kilometre it travels. What is the largest number of bananas that can be delivered at the market?

How can you add the 192.168.100.0/30 network to EIGRP without involving the 192.168.100.4/30 network as well?

R1#sh ip nat translations Pro Inside global Inside local Outside local Outside global icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11 30.1.1.1:11 icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12 20.1.1.1:12 icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13 21.1.1.1:13 icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14 31.1.1.1:14 R1# So my question is that after every ip address [:] is used & some number. 15.1.1.1{:11}... what is this colon & number indicate. Can anyone tel me this..!!! Thanking you advance. Shahin

what is the need og jitu(config)#ip helper address can any one exaplain it briefly specially shain i am looking towards you.Becoz you are the only one who can solve my that problem not even jitendera sinha

Which of the following is not a characteristic of link-state routing protocols? ❍ A. VLSM support ❍ B. Route summarization at any bit level ❍ C. Full routing updates at regular intervals ❍ D. Discontiguous network support

Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.

Which of the following encapsulation types can be used on leased-line connections? (Choose two) ❍ A. HDLC ❍ B. Frame Relay ❍ C. ISDN ❍ D. PPP

Wipro,

What is the most common layer 2 device? A. Hub B. Bridge C. Switch D. Router

IBM,

Which IEEE standard is used to define Wi-Fi? A. IEEE 802.3 B. IEEE 802.5 C. IEEE 802.11h D. IEEE 802.11c E. IEEE 802.11

Infosys,

Which network mask should you place on a Class C network to accommodate a user requirement of ten subnetworks? A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248

1 what is private vlam 2 if there is a router which have two fast Ethernet from from fa0/0 192.168.10.0/24 network is connected from fa0/1 192.168.20.0/24 network is connected all bacsic routing is done will they communicate 3 what is difference between snmp v1 v2 and v3 what difference between name and stranded access list

A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?

TCS, Wipro,

Is it possible that in a switched network that any port of the switch can be infected with any kind of viruses that jamed and create more traffic in network which cause slow network performance?

HCL,