Given the following output, how can we close Telnet session
2? (Choose two)
CCNA2620#show sessions
Conn Host Address Idle Conn Name
1 131.108.100.152 131.108.100.152 0 131.108.100.152
*2 126.102.57.63 126.102.57.63 0 126.102.57.63
❍ A. Press the Enter key and enter exit.
❍ B. Enter disconnect 2.
❍ C. Press the Enter key and enter disconnect 2.
❍ D. Enter close 2.
- 1 Answers
- 4158 Views
- I also Faced
- E-Mail Answers
How arp brings mac address for switch?
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP
Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability
Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.
Which processes does TCP, but not UDP, use? A. Windowing B. Acknowledgements C. Source Port D. Destination Port
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains
Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199
How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets
Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099
What's the default CDP holdtime in seconds for Cisco routers? A.) 30 seconds B.) 180 seconds C.) 90 seconds D.) 60 seconds
How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three
CCNA 
