Answer / nitin

Handpump has check valves which opens in down direction to collect water and close in up direction to prevent water flow back.

what electricalcable size for 132kw motor 4pole

0 Answers  

---

what's the defiance between T beam and inverted beam.

0 Answers  

---

Question asked in prototech first round

0 Answers   Protech,

---

Question 96 - In infrared spectrum, one of the factors affecting peak location is the mass of the atoms. The stretching frequency of a bond connected to a lighter atom will be greater than the same bond connected to a heavier atom. (a) For halogens like florine (F), chlorine (Cl), bromine (Br), iodine (I) and astatine (At), what is their IUPAC group number? Hint : The proton numbers for F, Cl, Br, I and At are 9, 17, 35, 53 and 85 respectively. (b) For the compounds of H-F, H-Cl, H-Br, H-I and H-At, which one has the lowest stretching frequency and which one has the highest stretching frequency? State the reasons.

1 Answers  

---

Question 95 - The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers  

---

What is the full form of cable type-ayry

0 Answers   TATA,

---

how we can calculate the load appeared on programable logic controller.and what is the method to calculate the scan time of PLC.

0 Answers   Siemens,

---

In an existing power plant (phase I) with step up transformers (3nos) with Ynd1 vector group to the 400KV bus bar,an extension power plant (phase II) with transformers (4nos) with Ynd11 vector group >. what are the consequences of such configuration ,please note that % impedance are also differ i.e. 15% & 10.5% the reason was that auxiliary supply interface is at different voltage levels i.e 400v & 6.6KV in phase i and phase II respectively .please advise ! Thank you !

1 Answers  

---

What's is the mechanism of for stroke engine

0 Answers   Medha Servo,

---

can DOL used with slip ring motor?

0 Answers   NTPC,

---

main() { char input[] = "SSSWILTECH111"; int i, c; for ( i=2; (c=input[i])!=''; i++) { switch(c) { case 'a': putchar ('i'); continue; case '1': break; case 1: while (( c = input[++i]) != '1' && c!= ''); case 'E': case 'L': continue; default: putchar(c);continue; } putchar(' '); } putchar(' '); }

1 Answers   Vector,

---

group discussion important topics

0 Answers   Aliens Group,

---