how many injection of any concentration should be injected
to determine the LOD/LOD?
- 3 Answers
- 7238 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / rishabh nagar
first to check Base line Signal to Noise by injecting 6 replicate injection of Blank, after getting a S/N ratio and maximum peak area of major peak observed in blank then make serial dilution method to check the response of peak at particular lambda max.when signal is achived at three times blank baseline signal.the relationship between the blank, the limit of detection (LOD), and the limit of quantification (LOQ) by showing the probability density function for normally distributed measurements at the blank, at the LOD defined as 3 * standard deviation of the blank, and at the LOQ defined as 10 * standard deviation of the blank. For a signal at the LOD
| Is This Answer Correct ? | 1 Yes | 0 No |
Which instrument used fbd fingerbag pore size identify purpose
i applied for drug inspector in andhra pradesh post
What should be the temperature and humidity for the tablet compression?
What is difference between method validation and Verification?
3 Answers Dr Reddys, Glenmark, Larus,
why we use matrixing method in stability study and on what basis time points are selected?
What is the Disintegration time for Hard gelatin Capsule in USP?
Why 3X sampling plan are implemented in process validation?
What is 21 CFR? And its significance.?
in performing of disintigration test in wich condition we use the disc&in wich condition we nt use the disk clarify wit reasn?
what is difference between uniformity of content and content uniformity as official test for tablet
what is medical representative
when will tamilnadu govt announce the exam for DRUG INSPECTOR post?
Pharmacy 
