While using logic design, explain the various steps that r
followed to obtain the desirable design in a well defined
manner?
Answer / sudeep
1. logic specification.
2. Truth table creation of the given logic,
3. logic minimization using karnuagh mapps
4. logic design using gates.
Is This Answer Correct ? | 12 Yes | 2 No |
Give the expression for CMOS switching power dissipation?
Mention what are three regions of operation of mosfet and how are they used?
For an AND-OR implementation of a two input Mux, how do you test for Stuck-At-0 and Stuck-At-1 faults at the internal nodes? (You can expect a circuit with some redundant logic)
Explain why present VLSI circuits use MOSFETs instead of BJTs?
Why is Extraction performed?
What is the difference between cmos and bipolar technologies?
What is Noise Margin? Explain the procedure to determine Noise Margin?
In the design of a large inverter, why do we prefer to connect small transistors in parallel (thus increasing effective width) rather than lay out one transistor with large width?
A circuit has 1 input X and 2 outputs A and B. If X = HIGH for 4 clock ticks, A = 1. If X = LOW for 4 clock ticks, B = 1. Draw a state diagram for this Spec?
Explain about 6-T XOR gate?
What does the above code synthesize to?
Implement an Inverter using a single transistor?