Answer / sam

how is last class address is broad cast address

Answer / farooqniceboy

Broadcast IP Address is -- 255.255.255.255

samniceboy@aol.com

GT Faculty

Answer / satyanarayana

devieses in the same vlan are in the same broadcast domain.

broadcast 255.255.255.255.

Answer / jayaprakash

i dont know

Can you explain PPP link process step by step?

0 Answers   CCIE, Sawes,

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

2 Answers   HCL,

---

Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II

2 Answers  

---

Do you found the Cisco Certification 642-067 exam Guide ?

1 Answers  

---

Explain what is the default behavior of access-list?

0 Answers  

---

Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  

---

let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.

1 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

To which layer ICMP belongs

7 Answers   CMS,

---

Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN

1 Answers  

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

1 Answers  

---

what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  

---