Interested to Buy Any Domain ? << Click Here >> for more details...
What is HSRP and what is difference between HSRP and GLBP
- 2 Answers
- 7921 Views
- Infosys, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / cheralu kankala
hot standby routing protocal,hsrp is a cisco properatory
and GLBP is open standard
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / kaushal
hot standby routing protocol diff between HSRP & GBLP is
there is only one ACTIVE link in HSRP and one back up link
but in GBLP four MAC address is available for any request
so that it provide load balancing
| Is This Answer Correct ? | 3 Yes | 0 No |
What is the standard ISDN term for a native ISDN modem? A.) ET B.) LE C.) TE2 D.) TE3 E.) TA
Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24
what does PPTP use for encryption and authentication?
Why Authentication Header (AH) is not compatible with the network that using NAT?????? Jitu, looking for u specially...!!!! U knw why i m looking for u..!!!
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
What is 10base5 ethernet lans?
What is the different between console port and auxiliary port?
Frame relay technology works on which layer of osi model?
What is subnetting and why it is use?
here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.
Explain the difference between rip and ripv2?
what are the port numbers for DNS,FTP,TELNET,SMTP,NNTP
5 Answers Airtel, Walton Group,
CCNA 
