What is the default LMI type for Cisco Routers that are using
Frame-Relay?
A.) Annex D
B.) Q933A
C.) Cisco
D.) IETF
E.) ARPA
F.) Anex A
Answers were Sorted based on User's Feedback
Answer / robert
Default LMI is cisco .But it can supports Q933a,ANSI
| Is This Answer Correct ? | 1 Yes | 1 No |
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
What is the mau?
Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM
Company XYZ has an employee that works out of the home. The employee runs big client server applications and must quickly transfer large files. The company wants the best cost/benefit on this connection. What would be the most practical solution? A. an ISDN Basic Rate Interface (BRI) connection to the user at home B. a dedicated T1 connection to the user at home C. a dedicated Frame Relay connection to the user at home D. a standard 28.8 analog dialup connection to the user at home
Briefly explain the conversion steps in data encapsulation.
What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000
What does the following line for an access list do? 'access-list 101 deny tcp 3.4.5.0 0.0.0.255 any eq 23' A.) deny all ftp traffic B.) deny all ftp traffic from subnet 3.4.5.0 C.) deny all telnet traffic from subnet 3.4.5.0 D.) deny all ftp traffic to subnet 3.4.5.0 E.) deny all telnet traffic
Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.
Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) show routes protocol=ipx D.) show ipx E.) show ipx route
In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A
CPE is an acronym for which of the following? A.) Customer Premise Equipment B.) Central Processing Engineering C.) Customer Process Equipment D.) Central Processing Equipment
What is a benefit of a virtual LAN (VLAN)? A. It increases the number of broadcast domains B. It decreases the number of broadcast domains C. It increases the numberr of collision domains D. It decreases the number of collision domains E. Since it is a vitual Interface it never shuts down