Interested to Buy Any Domain ? << Click Here >> for more details...
Which memory component on a Cisco router contains the
dynamic system configuration?
ROM
NVRAM
Flash
RAM/DRAM
- 17 Answers
- 41277 Views
- HCL, Sun TV, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / vijayeendra
ITS NVRAM because IOS willget stored in it so thus
configuration also.
| Is This Answer Correct ? | 1 Yes | 0 No |
Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network
Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config
can we configure multiple as on single router using eigrp
What is the second best path name of eigrp?
Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
Identify the default IPX serial encapsulation? A.) Novell-Ether B.) SDLC C.) SNAP D.) HDLC
Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'
Why OSPF uses 2 Multicast IP
Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification
What does a router change in a packet when it forwards a packet to the next hop? * A: Destination physical address * B: Destination network address * C: Destination network address and the destination physical address
CCNA 
