Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

2 Answers  

---

Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port

1 Answers  

---

Request any body to explain the parameters of Ipsec vpn tunnel while creating a tunnel in Cisco ASA.

3 Answers   HCL,

---

Which of these is the Private key? A. Bear B. Cave C. Indian D. Cowboy

1 Answers  

---

When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?

0 Answers  

---

Which layer is responsible for coordinating communication between systems? A.) Application B.) Network C.) Session D.) Transport E.) Physical F.) Data Link

2 Answers   HCL,

---

How to crimping cat cable without using crimping and any tool...........?

6 Answers   CTS, Wipro,

---

Which network mask should you place on a Class C address to accommodate a user requirement of two subnetworks with a maxximum of 35 hosts on each networks A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248

4 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

Define ios?

0 Answers  

---

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

Mention the conversion steps of data encapsulation?

0 Answers  

---