Answer / guest

Answer: B

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

What is the difference between switch, routers, and hub?

0 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

2 Answers  

---

Which command listed below sets the banner message when someone connects to the router? A.) message # B.) banner # C.) login banner # D.) description # E.) login description # F.) banner motd #

2 Answers  

---

what is lmi? how many type of lmi's we are using ...

1 Answers  

---

Which command will enable CHAP authentication on a serial interface that is using PPP? A.) encapsulation chap B.) ppp chap C.) ppp enable chap D.) ppp encapsulation chap E.) ppp authentication chap F.) ppp chap enable

2 Answers  

---

Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE

1 Answers  

---

What is the frame relay, in which layer it comes?

0 Answers  

---

Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp

3 Answers   CMS,

---

HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS PREFERED OVER ANY NETWORK PROTOCOL?

1 Answers   Bank Of India, TCS,

---

1.i have to pcs in the network 192.168.1.1 202.55.88.16 2. if that fails shud go through 122.16.1.3 and and if that comes back active it shud go through 202.55.88.16 itself

1 Answers  

---

What is 100BaseFX?

0 Answers  

---