1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Identify the 2 hardware components used to manage and/or
configure a

router?

A.) Auxiliary port

B.) ROM port

C.) Management port

D.) Console port

Question Posted / guest


Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary po..

Answer / guest

Answer: A D

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

Which of the following encapsulation types can be used on leased-line connections? (Choose two) ❍ A. HDLC ❍ B. Frame Relay ❍ C. ISDN ❍ D. PPP

10 Answers   Wipro,

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

Can Anyone tell what is aummarization??

5 Answers   Wipro,

Company XYZ has an employee that works out of the home. The employee runs big client server applications and must quickly transfer large files. The company wants the best cost/benefit on this connection. What would be the most practical solution? A. an ISDN Basic Rate Interface (BRI) connection to the user at home B. a dedicated T1 connection to the user at home C. a dedicated Frame Relay connection to the user at home. D. a standard 28.8 analog dialup connection to the user at home.

1 Answers  

hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha

0 Answers  




What key do you use to view the last command? A.) Ctrl+X B.) Ctrl+Z C.) Ctrl+E D.) Ctrl+P

1 Answers  

A router blocks ___________ Broadcasts Unicasts All packets Nothing

1 Answers  

What are the different memories that are used in a cisco router?

0 Answers  

What is the mau?

0 Answers  

How many types of data?

0 Answers  

Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0

3 Answers  

What is the difference between dynamic NAT and NAT overloading

4 Answers  

For more CCNA Interview Questions Click Here
Categories