Tell me when we use standard access-list?

0 Answers  

---

Explain what is 5-4-3 rule?

0 Answers  

---

When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents

1 Answers  

---

How many collisions are caused by transmitting and receiving frames simultaneously in a full-duplex Ethernet technology? A. one B. two C. none D. several

1 Answers  

---

The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM

1 Answers  

---

Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  

---

What is the simplest way to remotely configure a router?

0 Answers  

---

Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP

3 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

what is standard and extended acess list? what are the commands for extended and acess list?

3 Answers   HCL,

---

What are some standards supported by the Presentation layer?

0 Answers  

---