Which statement about switched and routed data flows is correct?
A. Switches create a single collision domain and a single
broadcast domain. Routers provide separate collision domains
B. Switches create separate collision domains but a single
broadcast domain. Routers provide a separate broadcast domain
C. Switches create a single collision domain and separate
broadcast domains. Routers provide a separate broadcast
domain as well
D. Switches create separate collision domains and separate
broadcast domains. Routers provide separate collision domains
- 1 Answers
- 6808 Views
- I also Faced
- E-Mail Answers
What is 10baset ethernet lans?
Tell me which cable called roll-over?
IPX routing updates occur how often? A.) Every 30 seconds B.) Every 60 seconds C.) Only as needed D.) When the remote router asks for an update
In which protocol you manually enable route summarization?
What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1
Hi Gyes, here is new question. can you provide answer of following question Like linux, can we windows as router? If yes how can we able to do this,
Identify the command mode necessary to enter the standard ping command? A.) Router(config)# B.) Router> C.) Router(std-ping)# D.) Router(config-if)#
How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets
What are partial updates?
As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.
Identify the keystroke to position the cursor to the beginning of a command line? A.) Ctrl-A B.) Ctrl-Ins C.) Ctrl-B D.) Ctrl-Z
Suppose a USER is saying he is not able to access the internet or page loading is slow what trobleshooting steps you will take to get it fixed
CCNA 
