hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

R1#sh ip nat translations Pro Inside global Inside local Outside local Outside global icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11 30.1.1.1:11 icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12 20.1.1.1:12 icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13 21.1.1.1:13 icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14 31.1.1.1:14 R1# So my question is that after every ip address [:] is used & some number. 15.1.1.1{:11}... what is this colon & number indicate. Can anyone tel me this..!!! Thanking you advance. Shahin

4 Answers  

---

Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?

0 Answers   Wipro,

---

Which types of packets used in EIGRP?

1 Answers  

---

comparative networking features windows linux

1 Answers  

---

How does a web page works though each layers ?

5 Answers   HCL, PBPL,

---

What does data packets consist of?

0 Answers  

---

Which protocol called rapid protocol?

0 Answers  

---

Tell me how much internal and external ad of eigrp protocol?

0 Answers  

---

What is the result of using a hierarchical addressing framework? A. increased availability of addresses B. decreased distance between routers C. increased router memory requirements D. no need to maintain routing information

2 Answers  

---

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---

what are the 3ree way for implementing vlan on cisco switches what is the layer hierarchy of the cisco what is the best place of implementing standard access list what is q stand for isdn these are the challanging question for me i am waiting for jitendera sinha answer(it is challenge for u i have seen lots of answer given by u )it is a challenge in the frendshipmode plz donot take other wise

2 Answers  

---