What command displays the OSPF section of the running-configuration?
How many Devices does OSPF & EIGRP Support
Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
As a system administrator, you perform an extended ping at the privileged EXEC prompt. As part of the display, you see "Set DF bit in IP header? [yes] :" What would happen if you answered no at the prompt. A. This lets the router fragment the packet. B. It tells the router not to fragment the packet. C. This lets the router direct the packet to the destination it finds in its routing table. D. It tell the router to send the packet to the next hop router.
What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network
When we use interface mode?
what is standard and extended acess list? what are the commands for extended and acess list?
what is full form of rst,smtps & http?
Identify the mode reflected by the following prompt 'Router'? A.) Setup B.) RXBoot C.) Boot mode D.) Privileged exec mode
To monitor IP igrp traffic, you can use "debug IP igrp transaction" or "debug IP igrp events". How do you display information about IPX routing update packets? A. debug routing B. debug ipx transaction C. debug ipx routing activity D. debug ipx events
whats the routing protocol supporting in both juniper , cisco routers.
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
Which of the following are examples of the Datalink Layer? A.) LLC B.) SQL C.) TCP D.) Token Ring E.) IP