Which cable do you use to connect a PC
directly to the fast ethernet interface
on a router. For example if you wanted
to do an IOS upgrade from your laptop?
- 5 Answers
- 10371 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / chandan kumar sharma
we can use standerd cross cable. this cable is used for
connect router to pc...
| Is This Answer Correct ? | 12 Yes | 1 No |
Answer / guest
There are two ways to connect our router to our PC -
a) Via Console Port.
b) Via Ethernet Port.
As we everybody know that console port is used to configure
router local administration & for this purpose ROLLOVER
cable (Console port to COM port)is used.
As up gradation purpose, we need to have CROSSOVER cable
(From Fa 0/1 of router to NIC's Ethernet/Fast Ethernet port).
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / mahesh
it is cross cable..bcoz(he is transfering ios ) he is not
configuring router,if u wnt configure then we need roolover.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / jitendera kumar sinha
ho chandan i think the roolover cable is wright answer of
that question
| Is This Answer Correct ? | 4 Yes | 5 No |
A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management
CCNA question and answer only for networking.
Which of the following are used by routers to learn routes to be added to the routing table? Ping and Traceroute MAC address resolution Acknowledgments and Sequence Numbers Routing updates and static routes
Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.
When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents
What is the Difference between Hub and Switch?
You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode
10 Answers Intel, Quark, Wipro,
Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
Which port numbers are used by TCP and UDP to set up sessions with other hosts? A.) 1024 and above B.) 6 and 17 respectively C.) 1-25 D.) 6-17
When a router knows the IP address, but does not know the MAC address of the device it wishes to contact, it uses the ARP (Address resolution protocol) to determine the MAC address. After it learns the MAC address, it stores this information in the ARP cache. What is the command to view the ARP cache? A.) sh mac B.) show cache C.) show arp D.) sh arp interfaces E.) show ip cache
Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it
CCNA 
