Interested to Buy Any Domain ? << Click Here >> for more details...
The -- terminal no editing -- command will perform what
function?
A.) Edit the contents of NVRAM
B.) Allows access to the terminal port
C.) Stops the advanced editing feature
D.) Enable password functions
- 2 Answers
- 10513 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C
The command to disable advanced editing feature is:
Router(config)#
terminal no editing
| Is This Answer Correct ? | 11 Yes | 0 No |
Answer / mohammad
Turns off the ability to use the previous keyboard
shortcuts
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco
What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace
What is a back off on an 802.3 networks? A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. It is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged
What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route
Identify the length of an IPX address and it's components? A.) 80 bits, 48 bits network and 32 bits node B.) 32 bits, 16 bits network and 16 bits node C.) None of the above D.) 80 bits, 32 bits network and 48 bits node
How do you find valid hosts in a subnet?
what is routing and routed protocol ?
Explain the difference between half-duplex and full-duplex?
Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup
Can you explain in a generic manner the packet of IPSec?
Which command can verify Application Layer connectivity between 2 hosts? A.) ftp B.) snmp C.) telnet D.) ping E.) traceroute
Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM
CCNA 
