How does PPP use LCP for link control?
No Answer is Posted For this Question
Be the First to Post Answer
7. What is an advantage to using switches in your network? A. Addressing of hosts by DHCP B. Ease of administration C. Stops broadcast storms D. Works like a repeater
What key do you use to view the last command? A.) Left Arrow B.) Ctrl-P C.) Up Arrow D.) Right Arrow
frends i am suffring from newfolder.exe virus in my server 2000 win how i have to remove it plz help me Jitendera sinha
Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)
Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX
What is the purpose of ARP? A.) IP to host name resolution B.) Host name to IP address resolution C.) Mac to IP address resolution D.) IP to Mac address resolution
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
You need to come up with a TCP/IP addressing scheme for your company. How many network IDs must you allow for when you define the subnet mask for the network? A.) One for each WAN link B.) One for each router interface C.) One for each NIC installed in each client D.) One for each subnet with hosts E.) One for each host ID
Which cable called roll-over?
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network
what is distance vector protocol link state protocol and what is the diffrence between them
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router