What is the purpose of ARP?
A.) IP to host name resolution
B.) Host name to IP address resolution
C.) Mac to IP address resolution
D.) IP to Mac address resolution
Answers were Sorted based on User's Feedback
Answer / tarunkakkar
d:
rarp changes mac address to ip address
whereas arp get mac address if ip address is known.
Is This Answer Correct ? | 4 Yes | 2 No |
Which of the following are examples of the Network Layer? A.) Token Ring B.) LLC C.) SQL D.) IP E.) TCP F.) IPX
What is a Frame Relay?
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
What is the key advantage of using switches?
What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.
Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename
What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet
Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort
HI ALL , wanted to know if the rstp protocol.. rapid spanning tree protocol .. is imp to study with ccna's point of view or study of STP will be enough.. in some books rstp is nt given like todd lamle however in icnd2 its explained in detail.. please suggest asap .. thanks ..
How would you configure one host name that points to two IP addresses? A. IP host jacob 1.0.0.5 2.0.0.8 B. IP jacob 1.0.0.5 2.0.0.8 C. IP host jacob 1.0.0.5 D. IP host duplicate "all"
Why Authentication Header (AH) is not compatible with the network that using NAT?????? Jitu, looking for u specially...!!!! U knw why i m looking for u..!!!
What does the Spanning Tree Algorithm (STA) do? A.) Restore lost frames B.) Builds routing tables for routing through an internetwork C.) Forward packets through a switch D.) STA is implemented by STP to prevent loops