Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map

1 Answers  

---

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

2 Answers  

---

Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

What are the difference between IPv4 & IPv6?? Can anyone explain more details about it..!!

9 Answers   HCL,

---

What is the multicast routing?

0 Answers  

---

You have OSPF traffic flooding your network via one of your router interfaces. Write the access list line that will deny all ospf traffic. Don't worry about the other lines of the access list.

1 Answers  

---

Identify the default encapsulation on serial interfaces? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP

2 Answers  

---

Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery

1 Answers  

---

Differentiate User Mode from Privileged Mode?

0 Answers  

---

Which command will enable debugging for IPX RIP updates? A.) debug ipx B.) debug ipx rip C.) debug ipx rip activity D.) debug rip E.) debug ipx packets

2 Answers  

---

what is ip address?

3 Answers   HCL,

---

In stead of 0.0.0.0 wild card mask what you can write after ip?

0 Answers  

---