IP extended access lists use which of the following as a
basis for
permitting or denying packets?
A.) destination address
B.) all of the above
C.) protocol
D.) source address
E.) port
Answers were Sorted based on User's Feedback
An optional parameter on an IPX access is the 'LOG' parameter. This records access-list violations when a packet matches. What else does the 'LOG' option do? A.) Records the number of times that a packet matches the list. B.) Return a message to user who is denied access the by list. C.) Notifies an SNMP Agent. D.) Saves the log to NVRAM. E.) Send an SNMP Trap.
Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP
What are the two components of an IPX address? A. network number IP address B. MAC address node number C. network number MAC address D. network number arched number
the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected??
Can you explain L2TP?
switch kitne volt per work karta hai. what is frame realy. what is isdn and pri and bri.
What is window in networking terms?
friends i have some problem in the acess list plz help me out. purbi sinha. 1 what is the diffrence b/w inbound and out bound access list 2 what is main diffrence betwwen standred acesslist and extended access list 3 where should i keep stnadred access list and exatended access list i mean at which interface and why? 4 why wild card masking is used 5 what is switch febric in switching plz help me out i am litle bit confuse
Name the command we use for ping in ipv6?
whats the routing protocol supporting in both juniper , cisco routers.
Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.