Explain how many ways to access router?
No Answer is Posted For this Question
Be the First to Post Answer
What’s the simplest way to remotely configure a router?
Which of the following is an example of a Transport Layer protocol? Ethernet IP TCP RS-232
You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.
Hi all, Sorry, but i want to say that right now i have around two years experience and doing the job as a network engineer(ccna certified).but i want switch job so please can tell me any opportunity.
Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP
What metric does rip use? How is the metric used to indicate an unreachable network?
The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
Which two describe frame tagging? A.) Examines particular info about each frame B.) A unique ID placed in the header of each frame as it traverses the switch fabric C.) A user- assigned ID defined to each frame D.) The building of filter tables
What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?