Which information must a router know in order to perform proper and pungent routing? A. destination application of an incoming packet B. number of other packets in a single flow of data C. destination network address of an incoming packet D. number of routers that also know a path to the destination

1 Answers  

---

which defined peer ip address an local subnet belong to crete? (Choose two)

0 Answers  

---

How convergence happen in ospf?

3 Answers   TCS,

---

Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24

1 Answers  

---

what is ACLs? what is the reasons to create ACLs?

1 Answers  

---

Which statement about Ethernet switches is true? A. Symmetric switching allows connection between pods of unlike bandwidth and does not require memory buffering B. Memory Buffering is used to prevent a bottleneck when pods of different bandwidth are connected on a symmetric switch C. The latency can be reduced if the switch utilizes the store and forward method of switching store and forward is better for error detection D. The cut through method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address

1 Answers  

---

what is native vlan any one explain sooraj

7 Answers   IBM,

---

What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Token_SNAP

1 Answers  

---

what is the subnet for the host ip address 172.16.210.0/22

8 Answers   IBM, Microland,

---

The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  

---

what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  

---

What is a Window in networking terms?

0 Answers  

---