Why mac address called physical address?
- 1 Answers
- 1319 Views
- I also Faced
- E-Mail Answers
Answer / Omprakash Varanwal
A MAC (Media Access Control) address, also known as a hardware address or physical address, is given to a network interface controller (NIC) by the manufacturer. The primary reason it's called a 'physical address' is because it uniquely identifies each device on the physical network. This is crucial for proper communication between devices in a local area network (LAN).
| Is This Answer Correct ? | 0 Yes | 0 No |
In stead of 0.0.0.0 wild card mask what you can write after ip?
Can you define in short what VPN is?
what is the difference between a passive and active hub?? which is better ??
What is default time of hello packets in ospf?
Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart
heyyy frnds can please me that which institue is good for me in hardware and networking because im coming frm Dubai
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services
How many fillers we can put in one ip of ipv6?
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
On which base switches take decisions?
What is a network subnet?
CCNA 
