Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following statements is false?
If your Frame Relay link does not support inverse ARP, you
must manually map DLCIs to network Address.
One of the major advantages of Frame Relay is its ability
to connect to multiple PVCs using only one physical link.
DLCI addresses are determined by the network administrator
when installing the network.
Which of the following statements is false?
If your Frame Relay link does not support inverse ARP, you
must manually map DLCIs to network Address.
One of the major advantages of Frame Relay is its ability
to connect to multiple PVCs using only one physical link.
DLCI addresses are determined by the network administrator
when installing the network.
In order for two ends of virtual circuits to
communicate using Frame Relay, their network addresses must
be mapped to DLCIs.
- 2 Answers
- 9239 Views
- Wipro, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / hemant
dlci are provided by the isp so the third option false
| Is This Answer Correct ? | 2 Yes | 0 No |
Can you explain PPP protocol?
What is a vlan? What does vlan provide?
What is difference between routing and routed protocols?
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM
Which ISDN specification deals with call Setup and Teardown? A.) Q-Series B.) J-Series C.) I- Series D.) C- Series E.) F-Series
Explain the types of resource sharing?
Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash
What is passive topology in ccna?
What are four benefits that can result from applying ISDN networking? (Choose four) A. Full time connectivity across the ISDN is spoofed by Cisco IOS routers using dial on demand routing (DDR) B. Small Once and Home Once sites can be economically supported with ISDN Basic Rate Interface (BRI) servkps C. ISDN replaces Signaling System 7 (SS7) in the Public Switched Telephone Network (PSTIC) backbone D. ISDN can be used as a backup service for a leased line connection between the remote and central chaps E. Modem racking and cabling can be eliminated by integration of digital modem cards on Cisco IOS Network Acess Servers (NAS)
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
what is distance vector protocol link state protocol and what is the diffrence between them
CCNA 
