Interested to Buy Any Domain ? << Click Here >> for more details...
Which command line statement determines the number of seconds a
dialup connection can wait without any traffic before the
router hangs up?
A.) dialler max-time
B.) dialler timeout
C.) dialer idle-timeout
D.) dialer hang-up
E.) disconnect-timer
- 2 Answers
- 5530 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. mac-address 0005.1b00.5b58
what is the binary value of loop back address
which layer is responsible for flow control with sliding windows and reliability with sequence number and acknowledgement? A)Transport. B)Application C) Internet D)Network Interface
We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?
Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation
What are the possible ways of data exchange in ccna?
how will configure Nat
What command will display all connected OSPFv2 routers?
What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip
What does eq means?
in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks
Which way of communication bus topology use?
CCNA 
