Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following would not be displayed by the command
?sho cdp
neighbor detail??
A.) The incoming/outgoing interface.
B.) The hardware platform.
C.) One address per protocol.
D.) Amount of Flash Memory Available
E.) The routers hostname.
F.) The subnet mask, if IP is configured.
- 1 Answers
- 4282 Views
- I also Faced
- E-Mail Answers
what is distance vector protocol link state protocol and what is the diffrence between them
What is network?
In which two modes can the ICMP ping command be used? (Choose two) A. user B. privileged C. global configuration D. interface configuration
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.
How many types of memories are used in cisco router?
what is the full fom of ping
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
CCNA 
