Answer / m haja bahurudeen

Ans :A) Local Area Network

Answer / guest

Answer: A

Answer / mintoo ch

local area network

Answer / mintoo ch

local area network

IP RIP routing is conferred on a router but not all interfaces attach to RIP networks. What should you use to prevent all RIP routing updates from being sent through selecedc interfaces without using access lists? A. passive route B. default routes C. passive interface D. route update filtering

2 Answers  

---

Which information must a router know in order to perform proper and pungent routing? A. destination application of an incoming packet B. number of other packets in a single flow of data C. destination network address of an incoming packet D. number of routers that also know a path to the destination

1 Answers  

---

What is a protocol

13 Answers   Network, TATA,

---

What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

2 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

2 Answers  

---

---

What is the standard ISDN term for a native ISDN telephone? A.) ET B.) TE1 C.) TE2 D.) LE E.) TA

1 Answers  

---

What is the Difference between Switch and Bridge?

9 Answers  

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

2 Answers  

---

What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop

2 Answers  

---

Which of the following are used by routers to learn routes to be added to the routing table? Ping and Traceroute MAC address resolution Acknowledgments and Sequence Numbers Routing updates and static routes

1 Answers  

---

A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,

---