Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the true statements about the following access list:
Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23
Access-list 101 permit ip any any
A.) This access list prevents the host 192.10.172.0 from
telneting
B.) This access list prevents any telnet traffic from subnet
192.10.172.0/24
C.) This access list filters some telnet access
D.) This access list denies any telnet traffic to subnet
192.10.172.0/24
E.) This access list is invalid
F.) The netmask on the this access list is reversed
- 1 Answers
- 4856 Views
- HCL, I also Faced
- E-Mail Answers
Which feature should a routing protocol have to support vlsm?
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
How network gateway is different from routers?
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended
how to find network ID from IP address?without using network calc...
12 Answers Idea, Karbon, NIIT,
What is trigger rip and from which ios version it starts?
Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP
Select the most correct statement regarding client port address assignment. The client port always matches the destination port. To access a web page the client uses the source port of 80 and the destination port is dynamically selected. When a client requests a web page the destination port is 80 by default and the source port for the client is dynamically selected. The client source port is 1024 to get web pages and 1055 when retrieving ftp files.
Using the TCP/IP protocol suite a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses RARP requests D. It uses a router lookup table
as we know that isdn bri port come with either a u interface or some thing s/t interface what is the diffrenmce between them
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
I received a call from client that network is down. We have 100 or 1000 of switches and routers so how could we find the client switch and its port number? and useful commands to find this ?
CCNA 
