Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

Why we use debug command?

0 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

3 Answers  

---

Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity

1 Answers  

---

What are the different types of the password used in securing a cisco router?

0 Answers  

---

what is burst rate

1 Answers   ASD Lab,

---

Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp

1 Answers  

---

Which of the following is a characteristic of a switch, but not of a repeater? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

2 Answers  

---

what is hop count?

21 Answers   IBM, PalmChip,

---

Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP

1 Answers   Wipro,

---