Select the most correct statement regarding client port
address assignment.
The client port always matches the destination port.
To access a web page the client uses the source port of
80 and the destination port is dynamically selected.
When a client requests a web page the destination port
is 80 by default and the source port for the client is
dynamically selected.
The client source port is 1024 to get web pages and 1055
when retrieving ftp files.
- 2 Answers
- 4042 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ramesh
When a client requests a web page the destination port
is 80 by default and the source port for the client is
dynamically selected
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / jitendera sinha
i have tried to give the answer of flowing question.some of them are real stuff i have tried to best of my knowledge i don't know i am wright or wrong if you know then plz let us know
in that question i think ramesh is correct but i am not confirmed so i am not writing any answer for that
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What is the first step in data encapsulation? A.) User information is converted into data. B.) Frames are put into bits. C.) Data is converted into segments. D.) Segments are converted into datagrams and packets. E.) Packets are put into logical frame.
Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0
Identify the extended IP access-list number range? A.) 600 - 699 B.) 1 - 99 C.) 900 - 999 D.) 100 - 199
Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
Which of the following are Distant Vector protocols? A.) IGRP B.) RIP C.) OSFP D.) EIGRP
Operation of two PC connecting with brand new switches. (they expecting step by step arp ,broadcast,MAC table, RARP operation)
what is diffrence betwwen mpls and frame really
what is the network address?
Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199
What is the name of algorithm of eigrp protocol?
CCNA 
