Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the keystroke to position the cursor to the
beginning of
a command line?
A.) Ctrl-A
B.) Ctrl-Ins
C.) Ctrl-B
D.) Ctrl-Z
- 2 Answers
- 4862 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16
How do you configure a Cisco router to route IPX?
What are the generic parts of a network layer address? A. an intenetworks number and a URL B. a vendor code and a serial number C. a network number and a host number D. a broadcast number and a unicast number E. a domain identifier and a device identifier
Why OSPF uses 2 Multicast IP
Describe ICMP messages
Name the protocol which can do load balancing on unequal cost also?
What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet
Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe
Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com
What is the Function of Router?
CCNA 
