Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to configure the router to boot from an
alternate IOS located in flash?
A.) boot system flash IOS.exe
B.) boot system tftp IOS.exe 172.16.5.1
C.) boot system alternate IOS.exe
D.) boot system rom IOS.exe
- 1 Answers
- 4281 Views
- I also Faced
- E-Mail Answers
Hi There, I am currently studying my CCNA and doing quite a bit of practice exams. I recently came across a questions which totally confused my and I needs someone to explain it to me please, the questions is: Which routes are contained in the following summarisation address. 192.18.176.0/21. The posiible answers are, A. 192.18.183.255, B. 192.18.159.2, C. 192.18.194.160, D. 192.18.179.4, E. 192.18.183.41, F. 192.18.184.45. According to the answer sheet the correct ones are E and F, but when I work it out I get D,E and F, please help
Tell me which protocol called rapid protocol?
What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip
what is difference between hub and switch?
Which of the follow do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE
hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?
Name the different types of networks
There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp
Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.
Request any body to explain the parameters of Ipsec vpn tunnel while creating a tunnel in Cisco ASA.
Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in
What is the syntax of ipv4?
CCNA 
