Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
- 1 Answers
- 1498 Views
- I also Faced
- E-Mail Answers
Answer / Satnaam Singh
Before traffic can be sent to a router, it must first have a default gateway (default route) configured. The command used for this purpose is 'ip route 0.0.0.0 0.0.0.0 <router_IP>'.
| Is This Answer Correct ? | 0 Yes | 0 No |
Can you explain PPP protocol?
What do you understand by redundancy?
Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort
Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination
Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...
What is the difference between private ip and public ip?
How many Devices does OSPF & EIGRP Support
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended
What is the difference between cross cable and straight cable?
After how long keep alive messages exchange in eigrp?
What is DLCI?
What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II
CCNA 
