Answer / guest

Answer: C

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

2 Answers  

---

what is a routing ?what is the use of routing?

8 Answers   Google, IBM, Pacific, Tata Technologies,

---

Of the following, which reason applies to dividing a large network into two or more smaller networks? Performance Security Address Management All of the above

2 Answers  

---

Identify the purpose of the Trace command? A.) Explorer packet transmitting routing information B.) Test connectivity C.) Determine the path a packet is taking through the network D.) Transmits user data when buffers are full

2 Answers  

---

What is an advantage of UDP? Low Overhead High Overhead Reliable Not reliable

4 Answers  

---

What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo

1 Answers  

---

What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers  

---

GUY i Have attended one interview for the data craft and they are offering me L1 postion and i am working at l2 in cisco so there is no way to get in the datacraft i am posting here the question he asked to and i have tested the interviewer and i come to know he was not having any knowledge. His questions are-: 1) what is Vlan 2) what is stp and what is difference between stp and RSTP 3) what is HSRP and Diffrence betwwen HSRP and GLBP 4) how to configure HSRP 5) Scenario Based question ( if we have two router and both are connected and there are having redundancy means two interface of the router r1 is connected to the two interface of Router R2 (R1)-------------(R2 (R1)-------------(R2 Now he want to configure the router in such a Manner that if one link down second link should come up.My answer was HSRP and his is "F looting static routing was i wrong "i know F looting Static routing is Theoretically possible but it is not fusible in the scenario where you have multiple router connected to the same router and if you have configured sub interface i challenged him and he lost The Battle and he get angary 5) what the eigrp and how it works 6) tables in eigrp 7) the information of feasible successor where it saved now after answering these all he was very angry ( i can fill the heat) 8) then he come to ospf Area type ( he was also not aware) 9) LSA type and its working ( he was also having confusion ) 10) then is asked routing by rummer( Theroy) 11) hello and dead intervel of EIGRp (theory) 12) Selection cretaria for Eigrp slecting best path ( here we have a long discussion on MTU and he lost the battle and agree That MTU never comes in the accounts in this process) 13) what is ACL type of acl ( here he was aware of TWO type Standard and extended i have told him 5 type( he again get Angry) We have 2hr of discussion and and he told me he will call me latter but i know he never call

1 Answers   IBM,

---

Identify the 2 types of access-list filters that control SAP traffic? A.) Novell-ether B.) Arpa C.) Input-sap-filter D.) Round-robin E.) Output-sap-filter

1 Answers  

---

A router on one side of a PPP link uses the resonance RTR1 and the password COPP1-PWD. Which configuration line on RTR1 enables a connection between RTR1 and another router named RTR2? A. username, RTR2 password COPR1-PWD, B. username, RTR1 password COPR1-PWD, C. username, RTR2 password COPR2-PWD, D. username, RTR1 password COPR2-PWD,

1 Answers  

---

what is Bandwidth capping

0 Answers   Infosys,

---

Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

1 Answers   Rooman,

---