Answer / guest

Answer: A

At the time when Cisco first supported IPX, Novell-Ether (Novell

proprietary 802.3 'raw') was the default frame type for
NetWare 2.x and

3.x file servers. Now, Novell has changed their default
frame type to

802.2 (which is really IEEE 802.3 Ethernet, with LLC 802.2
headers).

What is the default bandwidth size of t1 routers?

0 Answers  

---

what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  

---

What are the OSPF router rules????

6 Answers   NIIT,

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

1 Answers  

---

Identify 2 features of PPP CHAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) Less secure then PAP D.) Local router 'challenges' the remote router

1 Answers  

---

What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop

2 Answers  

---

When using TCP, after a session is open, the applications can adjust the amount of segments they receive before sending an acknowledgment. This behaviour is known as ______________. FCS Windowing MTU adjustment Flexible Send Path

1 Answers  

---

Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart

10 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers   Wipro,

---

Explain what is formula of hold down time of eigrp protocol?

0 Answers  

---

Which protocol carries messages such as destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, Redirect, Echo, Echo Reply, Timestamp, Information Request, Information Reply, Address Request, and Address Reply? A. ICMP B. UDP C. TCP D. TFTP E. FTP

2 Answers   TCP,

---

What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates

1 Answers  

---