Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for putting 1s and 0s into a logical
group?
A.) Session
B.) Application
C.) Transport
D.) Data Link
E.) Physical
F.) Network
- 3 Answers
- 8804 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D
Frames are broken down into 1s and 0s and placed onto the
physical
medium by the Data Link layer.
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / rakesh kumar
D
At the data link layer, Zeros and ones are logically
grouped into frames with a defined beginning and end.
Rakesh Kumar
Fresher (CCNA)
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / meer
Which layer is responsible for putting 1s and 0s into a logical
| Is This Answer Correct ? | 0 Yes | 0 No |
What command will display all connected OSPFv2 routers?
You want to clear the outputs on your serial interface showing errors on the interface. Which command do you type?
We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?
from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us
What are two purposes for segmenting a network with a bridge? (Choose two) A. to reduce collisions B. to increase collisions C. to add collision domains D. to reduce collision domains E. to have more broadcast domains
What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip
Which way of communication bus topology use?
What is difference between standard and extended access-list
17 Answers College School Exams Tests, HCL, Wipro,
Select the correct statements about PPP and SLIP for WAN communications? A. PPP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols. B. PPP can only transport TCP/IP C. SLIP can only transport TCP/IP. D. SLIP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols.
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash
CCNA 
