What does the acronym ARP stand for?
A.) Address Resolution Phase
B.) ARP Resolution Protocol
C.) Address Resolution Protocol
D.) Address Recall Protocol
- 2 Answers
- 7474 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C
The Address Resolution Protocol (ARP) resolved IP addresses
to MAC
addresses.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / kapilasdhir
C.) Address Resolution Protocol
·ARP was invented for this reason . It relates IP’s to MAC
addresses only on media that supports broadcasts .
·Each node maintains a cache called the ARP cache , which
holds a table of IP’s against MAC addresses .
| Is This Answer Correct ? | 6 Yes | 0 No |
Tell us the name of algorithm of eigrp protocol?
What is the attenuation?
What are the two components of an IPX address? A. network number IP address B. MAC address node number C. network number MAC address D. network number arched number
As a system administrator, you want to debug igrp but are worried that the "debug IP igrp transaction" command will flood the console. What is the command that you should use? A. debug IP igrp event B. debug IP igrp-events C. debug IP igrp summary D. debug IP igrp events
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full
Define class full protocol?
You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.
You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet
A router blocks ___________ Broadcasts Unicasts All packets Nothing
What is proxy-ARP and how it is used and configured
Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol
In which protocol supenetting is enable by default?
CCNA 
