Answer / guest

Answer: C

Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification

1 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

---

What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM

1 Answers  

---

Tell me how much hold down time of eigrep protocol?

0 Answers  

---

in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks

1 Answers  

---

Identify the command to display the configured IP routing protocols? A.) show protocols B.) show protocols all C.) show routing-protocols D.) show ip protocols

2 Answers  

---

What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.

1 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation

1 Answers  

---

How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?

7 Answers  

---

What is Standard ACLs?

5 Answers   HP,

---