Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 3 IP routing protocols?
A.) RIP
B.) AURP
C.) OSPF
D.) IGRP
E.) ARP
F.) ICMP
- 3 Answers
- 7004 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / haja bahurudeen m
Ans : A,C,D
Routing protocol
RIP
IGRP
EIGRP
OSPF
IS-IS
BGP
Routed protocol
IP
IPX
Appletalk
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / suraj kumar gupta
A.) RIP --Routing Information Protocol
B.) AURP-- Not Available
C.) OSPF--Open Shorted Path First
D.) IGRP--Interior Gateway Routing Protocol
E.) ARP--Address Resolution Protocol
F.) ICMP--Internet Control Message Protocol
A,C& D are the routing protocols......
| Is This Answer Correct ? | 3 Yes | 0 No |
What is bia?
What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP
what is the major difference between EIGRP & IGRP?
Which of the following is an example of the Network Layer? A.) TCP B.) IP C.) SQL D.) Token Ring E.) LLC
Which Standard IP Access list commands will deny only the source address 1.1.1.1? A.) access-list 9 deny host 1.1.1.1 B.) access-list 9 deny 1.1.1.1 255.255.255.0 C.) access-list 9 deny 1.1.1.1 0.0.0.0 D.) access-list 9 deny 1.1.1.1 0.255.255.255 E.) access-list 9 deny 1.1.1.1 255.255.255.255
The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP
Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port
Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register
What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.
Which statement is true? A. While bridges are used to segment networks, they will not isolate broadcast or multicast packets. B. A bridge looks at every packet within its network segment and works like a hub re-broadcasting the packet if the destination is within its network segment. C. A bridge maintains a table of the IP addresses of the hosts within its network segment and forwards the packet directly to the destination based upon the IP address. D. A bridge resets the hop count by keeping all packets within the network segment. Only packets addressed to a specific destination host outside the network segment are allowed to pass through the bridge.
Who controls mac address uniqueness and how?
What is formula of hold down time of eigrp protocol?
CCNA 
