Mention what is the difference between dynamic ip and static ip addressing?

0 Answers  

---

Given the following descriptions of layers of the OSI model 1) This layer segments and reassembles data into a data stream 2) This layer manages device addressing tracks the location of devices on the network and determines the best way to move data 3) This layer provides the physical transmission of the data and handles error notification network topology and flow control. Choose the statement that lists the layers in the order described above A. physical data link network B. physical session data link C. data link network transport D. data link transport network E. transport network data link F. transport data link network

2 Answers  

---

If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2

1 Answers  

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---

What is the update period for rip?

0 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

What is the command use to add a banner to a cisco router configuration?

0 Answers  

---

Which type of switching reads in the entire frame before forwarding it? A.) Pause-and -forward B.) Store-and-Forward C.) Inverse ARP D.) Fast Forward E.) Cut-Through F.) Routing

2 Answers  

---

Mention what is the difference between the switch, hub, and router?

0 Answers  

---

HI friends mine one of the friends have ask a good question i also donot know the answer so i am putting here Please poet the answer no matter it is wright or wrong put yours view here The question is like that when we are going to configure ospf then there are three way 1st way router ospf 10 netwrok 192.168.1.0 0.0.0.255 area 0 network 192.168.2.0 0.0.0.255 area 0 the 2nd way is like that router ospf 10 netwrok 192.168.0.0 0.0.255.255 area 0 but he inrodused the thrird way like router ospf 10 netwrok 192.168.00000001.0 < ?.?.?.?>area 0 router ospf 10 netwrok 192.168.00000010 <?.?.?.?>area 0 now problem is that what should i put the mask in this way so i puted ? sign Please solve this problem i think this is good one plz donot see for answer please contribute any thing i am reqesting Than you Jitendera kuamr sinha

5 Answers  

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

Differentiate between broadcast domain and collision domain

0 Answers  

---