Interested to Buy Any Domain ? << Click Here >> for more details...
What are the two most common request/reply pair with ICMP
messages when using the ping command? (Choose two)
A. echo reply
B. echo request
C. source quench
D. fragment onset
E. information redirect
F. destination reachable
G. echo control message
- 1 Answers
- 7275 Views
- I also Faced
- E-Mail Answers
For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix
Can anybody tell me how to configure a cisco router?
Mention what is the difference between the switch, hub, and router?
The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP
Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability
Why Operating System Have only 65,535 port Numbers
Which protocol supenetting is enable by default?
What is VLSM? Why we Create? When we Create? Implement VLSM with example?
How many ways are there to implement VPN architecture?
Which information must a router know in order to perform proper and pungent routing? A. destination application of an incoming packet B. number of other packets in a single flow of data C. destination network address of an incoming packet D. number of routers that also know a path to the destination
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free
CCNA 
