Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet?

Which IP Address Class can have 64,000 subnets with 64,000

hosts per subnet?

A. Class B

B. Class A

C. Class C

D. Class D

Question Posted / guest

2 Answers
11712 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet? A. Class B B. ..

Answer / guest

Answer: A

IP Address Class

Possible Subnets Possible Hosts

254 A 16M

64K B 64K

16M C 254

Is This Answer Correct ?

13 Yes

5 No

Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet? A. Class B B. ..

Answer / m haja bahurudeen

Ans : A

Class A
Subnet : 254 host : 16 million

Class B
Subnet : 65554 host : 65554

Class C
Subnet : 16 million host : 254

Is This Answer Correct ?

2 Yes

4 No

Post New Answer

More CCNA Interview Questions

Which ipsec rule is used for the olympia branch and what does it define?

0 Answers

In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts

3 Answers

What is the bandwidth capacity of one ISDN B channel A. 64 kbps B. 128 kbps C. 512 kbps D. 1.54 mkbps

3 Answers

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers

You receive "input filter list is 800 and output filter list is 801" as part of the output from a show interfaces command. What kind of traffic are you filtering? A. IPX/SPX B. TCP/IP C. LocalTalk D. DDR

1 Answers

Explain the draw back of ospf protocol?

0 Answers

Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP

4 Answers

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

1 Answers

What is the multicast routing?

0 Answers

The "ipx delay number" command will allow an administrator to change the default settings. What are the default settings? A. For LAN interfaces, one tick; for WAN interfaces, six ticks B. For LAN interfaces, six ticks; for WAN interfaces, one tick C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks D. For LAN interfaces, five ticks; for WAN interfaces, zero Ticks

1 Answers

Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.

1 Answers Sutherland,

LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server

1 Answers

For more CCNA Interview Questions Click Here