Hi all,

Sorry, but i want to say that right now i have around two
years experience and doing the job as a network
engineer(ccna certified).but i want switch job so please can
tell me any opportunity.



Hi all, Sorry, but i want to say that right now i have around two years experience and doing the..

Answer / gurpreetbangi

hey man u have to do ccnp,ccie... "trap of cisco"

Is This Answer Correct ?    6 Yes 2 No

Post New Answer

More CCNA Interview Questions

When you cords an IP address on a place router which command stale the IP processing on the interface? A. ip enable B. network ip-address C. ip address ip-address subnet mask D. the exit command from the enabled configuration E. copy running-configuration to startup-configuration

3 Answers  


What is difference between Store-and-Forward, cut-through, Fragment-Free Method?

2 Answers   HCL, Microsoft,


Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts

1 Answers  


What command would you use to find out the names of Novell servers on a network? A. show ipx servers B. show ipx hosts C. show ipx sap D. show ipx nodes.

1 Answers  


What is EIGRP?

0 Answers  






Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity

1 Answers  


When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

2 Answers  


Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  


Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  


What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

1 Answers  


Which service takes information from multiple sources and allocates bandwidth on a single media? A. Time-division Multiplexing (TDM) B. Signaling System 7 (SS7) C. X.25 D. Frame relay

1 Answers  


How convergence happen in ospf?

3 Answers   TCS,


Categories