Which protocol works at the Internet layer and is
responsible for
making
routing decisions?
A.) UDP
B.) IP
C.) TCP
D.) ARP
- 5 Answers
- 6430 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ramesh kumar
network layer:in this mainly 2 protocol are working.
1. Routed protocol:it is responsible for select the best
path. i.e depending upon routing protocol what we have
configured.ex:rip,ospf,eigrp.
2.routing protocol:it is responsible for carry the data
from source to distnation with the help of logical address
(IP address)
| Is This Answer Correct ? | 0 Yes | 0 No |
hi ramesh,
actually routing protocol only , determines the best path of packet through an internetwork. i.e rip,ospf,eigrp
routed protocol is responsible for carry the data
from source to distnation with the help of logical address
(IP address).that is it determine the method of packet delivery
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector
What do the following statements in an extended access list accomplish? access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0 0.0.0.255 eq 21 access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0 0.0.0.255 eq 20 access-list 101 permit TCP 172.16.4.0 0.0.0.255 0.0.0.0 255.255.255.255 A. This will block ftp traffic. B. This will block http traffic. C. This will permit ftp traffic. D. This will permit tftp traffic.
Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification
What causes a triggered update to reset the router hold-down timer?
Can you explain PPP link process step by step?
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction
What is the simplest way to remotely configure a router?
Identify the 2 types of access-list filters that control SAP traffic? A.) Novell-ether B.) Arpa C.) Input-sap-filter D.) Round-robin E.) Output-sap-filter
Name the command we give on privilege mode for coming back to user execution mode?
Which layer allows multiple Ethernet devices to uniquely identify one another on the Datalink layer? A.) Transport B.) Session C.) Network D.) Datalink - MAC Sublayer E.) Datalink - LLC Sublayer
Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx
raid can be used in? 1 NT 2 Netware 3 all of above mine answer -NT
CCNA 
